CONSTRUCTION
Each VVT-i controller (camshaft timing gear assembly or camshaft timing exhaust gear assembly) consists of a housing driven from the timing chain and a vane coupled with the intake or exhaust camshaft.
Both the intake and exhaust sides have a 4-blade vane.
The oil pressure sent from the advanced or retarded side path at the intake and exhaust camshafts causes rotation in a VVT-i controller vane circumferential direction to vary the intake and exhaust valve timing continuously.
When the engine is stopped, a lock pin locks the intake camshaft at its most retarded position and the exhaust camshaft at its most advanced position, to ensure that the engine starts properly.
An advance assist spring is provided on the exhaust VVT-i controller (camshaft timing exhaust gear assembly). This spring applies torque in the advance direction when the engine is stopped, thus ensuring the engagement of the lock pin.
| *1 | Housing | *2 | Vane (Fixed on Intake Camshaft) |
| *3 | Intake Camshaft (Camshaft) | *4 | Lock Pin |
| *a | Lock Pin Operation | *b | Engine Stopped |
| *c | Engine Operating | - | - |
|
Oil Pressure | - | - |
| *1 | Housing | *2 | Lock Pin |
| *3 | Sprocket | *4 | Exhaust Camshaft (No. 2 Camshaft) |
| *5 | Advance Assist Spring | *6 | Vane (Fixed on Exhaust Camshaft) |
OPERATION
Advance
When the camshaft timing oil control valve assembly is operated as illustrated below by the advance signal from the ECM, the resultant oil pressure is applied to the timing advance side vane chamber to rotate the camshaft in the timing advance direction.
| *1 | Vane | - | - |
| *a | Rotation Direction | *b | From ECM |
| *c | Oil Pressure | *d | In |
| *e | Drain | - | - |
| *1 | Vane | - | - |
| *a | Rotation Direction | *b | From ECM |
| *c | Oil Pressure | *d | Drain |
| *e | In | - | - |
Retard
When the camshaft timing oil control valve assembly is operated as illustrated below by the retard signal from the ECM, the resultant oil pressure is applied to the timing retard side vane chamber to rotate the camshaft in the timing retard direction.
| *1 | Vane | - | - |
| *a | Rotation Direction | *b | From ECM |
| *c | Oil Pressure | *d | Drain |
| *e | In | - | - |
| *1 | Vane | - | - |
| *a | Rotation Direction | *b | From ECM |
| *c | Oil Pressure | *d | In |
| *e | Drain | - | - |
Hold
After reaching the target timing, the valve timing is held by keeping the camshaft timing oil control valve assembly in the neutral position unless the traveling state changes. This adjusts the valve timing at the desired target position and prevents the engine oil from running out when it is unnecessary.