CONSTRUCTION
Magnetic Resistance Element (MRE) type sensors are used for the crank position, intake cam position and exhaust cam position sensors.
The timing rotor of the crankshaft has 34 teeth, with 2 teeth missing. Based on these teeth, the crank position sensor transmits crank position signals (NE signal) consisting of 33 high or low output pulses every 10° per revolution of the crankshaft. The ECM uses the NE signal for detecting the crank position as well as for detecting the engine speed. It uses the missing teeth signal for determining the top dead center.
To detect the cam position, a timing rotor on the intake and a timing rotor on the exhaust camshaft are used to generate 3 (3 high output, 3 low output) pulses for every 2 revolutions of the crankshaft.
| *1 | Crank Position Sensor | *2 | Timing Sprocket |
| *3 | Exhaust Cam Position Sensor (No. 1 Crank Position Sensor) | *4 | Intake Cam Position Sensor (No. 1 Crank Position Sensor) |
| *5 | Timing Rotor | - | - |
An MRE type sensor consists of an MRE, a magnet and a sensor. The direction of the magnetic field changes due to the profile (protruding and non-protruding portions) of the timing rotor, which passes by the sensor. As a result, the resistance of the MRE changes, and the output voltage to the ECM changes to either high or low. The ECM detects cam position based on this output voltage.
The differences between the MRE type sensor and the pick-up coil type sensor used on a conventional model are as follows.
An MRE type sensor outputs a constant level of Hi/Lo digital signals regardless of the engine speed. Therefore, an MRE type sensor can detect the positions of the crankshaft and camshaft at an early stage of cranking.
A pick-up coil type sensor outputs analog signals with levels that change with engine speed.