Home › Engine / Hybrid System › 2NR-FE STARTING › STARTING SYSTEM › from 2016.04
NM30M0E _51 Engine / Hybrid System _053134 2NR-FE STARTING _0257548 STARTING SYSTEM GE GENERAL F

2NR-FE STARTING  STARTING SYSTEM  GENERAL  GENERAL  


OUTLINE


a.

The PA1.0 starter is a conventional planetary reduction type starter.


b.

A cranking hold function is used on models with the smart entry and start system. Once the engine switch is pushed, this function operates the starter until the engine starts.

W132144C01
3.646,3.177 3.958,3.375 0.313,0.198 10 false *a
*a Length - -




SPECIFICATION


Starter Type PA1.0
Length 121.2 mm (4.77 in.)
Weight 2050 g (4.5 lb.)
Rating Voltage 12 V
Rating Output 1.0 kW
Rotating Direction (Viewed from Pinion Side) Clockwise


PRECAUTION


a.

The cranking hold function has the following safety features:

i.

While the engine is running normally, the starter does not operate.


ii.

Even if the driver keeps pressing the engine switch, the certification ECU (smart key ECU assembly) stops the output of the STAR and ACCD signals when the engine speed becomes higher than 700 rpm. Thus, the starter operation stops and the certification ECU (smart key ECU assembly) energizes the ACC relay.


iii.

In case the driver keeps pressing the engine switch and the engine does not start, the certification ECU (smart key ECU assembly) stops the output of the STAR and ACCD signals after 30 seconds have elapsed. Thus, the starter operation stops and the certification ECU (smart key ECU assembly) energizes the ACC relay.


iv.

Also, if the certification ECU (smart key ECU assembly) cannot detect a continuous engine speed signal although the starter is operating and this continues for 6 seconds, the certification ECU (smart key ECU assembly) will stop sending out STAR and ACCD signals. As a result, the starter will stop operating and then the certification ECU (smart key ECU assembly) will energize the ACC relay.