Home › Engine / Hybrid System › 1NR-FE FUEL › FUEL SYSTEM › from 2016.04
NM30M0E _51 Engine / Hybrid System _053517 1NR-FE FUEL _0259803 FUEL SYSTEM DE DETAILS F

1NR-FE FUEL  FUEL SYSTEM  DETAILS  FUEL TANK  


CONSTRUCTION


a.

Low permeability has been realized through the use of the multiple layer plastic fuel tank assembly. This fuel tank assembly consists of 6 layers using 4 types of materials.


b.

A fuel drain mark has been provided at the lowest position of the fuel tank assembly. When dismantling (scrapping) the vehicle, drain fuel by drilling a hole at the drain mark.

W132148C01
5.427,1.385 5.75,0.833 5.75,0.833 5.917,0.833 true 5.427,1.552 5.75,1.083 5.75,1.083 5.917,1.083 true 5.427,1.656 5.75,1.333 5.75,1.333 5.917,1.333 true 5.479,1.74 5.896,1.74 true 5.49,1.802 5.75,2.167 5.75,2.167 5.917,2.167 true 5.417,1.917 5.75,2.417 5.75,2.417 5.917,2.417 true 4.448,4.406 4.833,3.417 4.833,3.417 5,3.417 true 3.833,0.542 4.146,0.74 0.313,0.198 10 false *a 5.948,0.75 6.26,0.948 0.313,0.198 10 false *1 5.948,1.01 6.26,1.208 0.313,0.198 10 false *2 5.958,1.26 6.271,1.458 0.313,0.198 10 false *3 5.948,1.667 6.26,1.865 0.313,0.198 10 false *4 5.938,2.094 6.25,2.292 0.313,0.198 10 false *3 5.948,2.344 6.26,2.542 0.313,0.198 10 false *1 1.615,3.156 1.927,3.354 0.313,0.198 10 false *b 5.042,3.344 5.354,3.542 0.313,0.198 10 false *5
*1 High Density Polyethylene (HDPE) *2 Regrind Material
*3 Adhesive *4 Ethylene Vinyl Alcohol Copolymer (EVOH)
*5 Fuel Drain Mark - -
*a Fuel Tank Wall Cross Section *b View from Bottom Side
V100135

Fuel Tank Assembly Outside
V100136

Fuel Tank Assembly Inside