Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM › from 2017.10
NM30M0E _56 Audio / Visual / Telematics _068332 PARK ASSIST / MONITORING _0333116 TOYOTA PARKING ASSIST-SENSOR SYSTEM GE GENERAL F

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  GENERAL  GENERAL  


OUTLINE


a.

The Toyota parking assist-sensor system uses the ultrasonic sensors to detect obstacles at the rear of the vehicle.


b.

The Toyota parking assist-sensor system informs the driver of the approximate distance between the ultrasonic sensors and an obstacle by sounding the No. 1 clearance warning buzzer.



PRECAUTION


a.

The detection function of the Toyota parking assist-sensor system may not operate properly in the following conditions:

i.

When ice, snow or mud gets on the ultrasonic sensors. If the material is removed, the system will work properly.


ii.

When an ultrasonic sensor is frozen. If the ultrasonic sensor is no longer frozen, the system will work properly.


iii.

When the ultrasonic sensors are covered with something. If the material is removed, the system will work properly.


iv.

When an accessory such as a license plate holder, etc. is installed within the detection area of the ultrasonic sensor.



b.

Especially in cold weather, a malfunction warning may occur (the buzzer may sound) due to frozen ultrasonic sensors. If the malfunction warning occurs, be sure to check the ultrasonic sensors. If the malfunction warning occurs and there is no mud, ice or snow on the ultrasonic sensors, an ultrasonic sensor may be malfunctioning.


c.

In the following conditions, the detection range may be affected:

i.

When foreign matter such as snow or mud gets on the ultrasonic sensors.


ii.

When the vehicle is operated in direct sunlight or in a freezing climate.



d.

The system may improperly detect obstacles in the following conditions:

i.

When the vehicle is being driven on bumpy road, gravel road or grass.


ii.

When the sound of horns from other vehicles, the sound of a motorcycle engine, the sound of the air brakes of a large truck, or an object that generates ultrasonic waves is in the vicinity.


iii.

When there is a downpour, or water is splashing on the vehicle.


iv.

When the vehicle posture tilts significantly.


v.

When an antenna for a wireless transmitter is mounted on the vehicle.


vi.

When the ultrasonic sensors are covered with ice, snow or mud.


vii.

When the vehicle travels alongside a tall curb or a square curb.


viii.

When other vehicles with sonar are nearby.


ix.

When a towing hitch is mounted on the vehicle.


x.

When the bumper is damaged.



e.

There are cases in which the objects listed below cannot be detected:

i.

Thin objects such as wire or rope.


ii.

Objects with surfaces that are too small to reflect ultrasonic waves such as wire mesh or a fence.


iii.

Objects that absorb sound waves such as cotton or snow.


iv.

Objects that have sharp edges.


v.

Objects that are short.


vi.

Objects that are tall and protrude at the top.



f.

Others

i.

Objects directly underneath the bumpers cannot be detected. Some objects located lower than the ultrasonic sensors, or thin objects, may not be detected as the vehicle comes close to these objects.


ii.

An object might not be detected if the vehicle is too close.


iii.

The ultrasonic sensors might not detect properly if they are exposed to strong shocks such as when being struck or having objects thrown at them.