Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE CONTROL SYSTEM › 2017.10–2018.01
NM30M0E _54 Brake _018312 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0090428 BRAKE CONTROL SYSTEM DE DETAILS F

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE CONTROL SYSTEM  DETAILS  STEERING ANGLE SENSOR  


CONSTRUCTION


a.

The steering angle sensor detects the steering direction and angle, and sends this signal to the skid control ECU.


b.

The steering angle sensor contains 2 sets of magnetic resistance elements that detect the rotational movement of a magnet that is built into the detection gear. Thus, the sensor detects the changes that occur in the magnetic resistance elements along with the rotational movement of the detection gear, in order to detect the rotational movement of the steering wheel.

for TMMIN Made
X110375C10
3.833,0.5 4.333,0.25 4.333,0.25 4.5,0.25 true 3.625,1.281 4.333,0.833 4.333,0.833 4.5,0.833 true 2.333,0.833 2.5,0.833 2.5,0.833 2.99,1.292 true 4.583,0.167 4.896,0.323 0.313,0.156 10 false *1 4.583,0.76 4.896,0.917 0.313,0.156 10 false *2 2.146,0.75 2.458,0.948 0.313,0.198 10 false *2
*1 Steering Angle Sensor *2 Detection Gear


for TMT Made
X136861C01
4.198,0.917 4.833,0.333 4.833,0.333 5,0.333 true 4,1.75 4.833,1.083 4.833,1.083 5,1.083 true 3.583,2 2.667,1.333 2.667,1.333 2.5,1.333 true 5.073,0.271 5.385,0.427 0.313,0.156 10 false *1 5.063,1.01 5.375,1.167 0.313,0.156 10 false *2 2.302,1.271 2.615,1.427 0.313,0.156 10 false *2
*1 Steering Angle Sensor *2 Detection Gear


NOTICE:

Do not remove the steering angle sensor from the spiral cable. If there is a malfunction in the steering angle sensor, replace the spiral cable with steering angle sensor.


HINT:

When removing and reinstalling the spiral cable with sensor sub-assembly, it is necessary to use a special procedure to prevent the center position of the steering angle sensor from becoming misaligned. For details, refer to the Repair Manual.