CONSTRUCTION
The front suspension support sub-assembly uses a construction in which the support is connected in one point. As a result, a compact and lightweight construction is offered.
A semi-airtight shock absorber dust cover which is attached to the absorber cap and moves with the shock absorber has been adopted. This reduces the gap between the shock absorber dust cover and shock absorber assembly, enhancing its ability to resist the intrusion of foreign matter. (Only for TMT made models)
A pigtail type of front coil spring is used where the top diameters are different, creating a compact and lightweight construction. Lateral force reduction springs are used to control the reaction force line of the front coil spring, and reduce the bending force applied to the front shock absorber assembly. This reduces suspension friction, delivering a very comfortable ride.
| *A | TMMIN Made Models | *B | TMT Made Models |
| *1 | Front Suspension Support Sub-assembly | *2 | Front Spring Bumper |
| *3 | Dust Cover | *4 | Front Shock Absorber Assembly |
| *5 | Front Coil Spring | *6 | Absorber Cap |
| *a | The illustrations shown are examples only. | - | - |