Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE CONTROL SYSTEM › from 2017.10
NM30M0E _54 Brake _018312 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0090428 BRAKE CONTROL SYSTEM DE DETAILS F

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE CONTROL SYSTEM  DETAILS  STOP LIGHT SWITCH  


CONSTRUCTION


a.

Models with LED Type Stop Light

i.

To provide high reliability, a non-contact type stop light switch assembly with magnetic sensor that employs the Hall IC as a detection device is used.


ii.

A magnet is mounted on the shaft that is pushed in by the brake pedal and a magnetic sensor is placed on the electronic circuit board so that changes in the magnetic flux density occurring between the magnet and magnetic sensor due to shaft movement can be detected. The stop light switch converts such detected changes into an electrical signal, outputting it as an on or off signal.


iii.

A semi-conductor relay has been built into the electronic circuit board to integrate a stop light actuation relay, which was separately provided, into the switch, reducing the number of components.

X131912C01
1.5,2.25 1.667,2.25 1.667,2.25 1.833,1.635 true 4.833,0.5 4.667,0.5 4.667,0.5 4.083,1.25 true 5.5,0.417 5.333,0.417 5.333,0.417 4.583,1.167 true 4.542,0.333 4.333,0.333 4.333,0.333 3.792,1.25 true 2.917,0.583 3.083,0.583 3.083,0.583 3.781,1.417 true 1.344,2.167 1.656,2.365 0.313,0.198 10 false *1 4.875,0.385 5.188,0.583 0.313,0.198 10 false *3 5.563,0.323 5.875,0.521 0.313,0.198 10 false *4 4.188,2.25 4.5,2.448 0.313,0.198 10 false *a 4.604,0.208 4.917,0.406 0.313,0.198 10 false *3 2.729,0.469 3.042,0.667 0.313,0.198 10 false *2
*1 Shaft *2 Magnet
*3 Magnetic Sensor *4 Electronic Circuit Board
·

Semi-conductor Relay


*a Cross Section - -
V100135

Direction the brake pedal is depressed. - -