CONSTRUCTION
The structure of the front bumper reinforcement has been formed into a B-shaped cross section to reduce the number of reinforcement materials while the strength is maintained. In addition, an open cross sectional shape is used on the radiator support, reducing weight. Furthermore, the front side member and bumper arm has been made as a single unit to eliminate connecting components, achieving a lighter weight.
| *1 | Radiator Support | *2 | Front Bumper Reinforcement |
| *3 | Extension Front Side Member | *4 | Front Side Member |
| *a | A-A Cross Section | - | - |
Sufficient rigidity has been provided by using the outer cowl top panel as a framework cross member to smoothly connect the left and right front suspension towers. In this way, good driving stability has been provided.
| *1 | Front Spring Support Plate | *2 | Cowl Top Panel |
The thickness of the dash panel and front spring support plates has been increased to enhance the body rigidity, contributing to the maneuvering stability.
| *1 | Front Spring Support Plate | *2 | Dash Panel |
Three enlarged braces, one on the center of the floor and on each area where the rear suspensions are mounted, to enhance the whole body torsional rigidity, contributing to the maneuvering stability.
| *1 | Center Brace | *2 | Brace |
The thickness of the strainer panels and upper back panel has been increased. Furthermore, braces have been added. As a result, the rigidity against impacts coming from the suspensions has been further enhanced.
| *1 | Brace | *2 | Upper Back Panel |
| *3 | Strainer Panel | *4 | Room Partition Panel |
In order to enhance the rigidity against counter twisting forces, the thickness of the panels around the rear wheel housings and the roof side inner rear panels has been increased. Also, reinforcements have been provided on the openings of the back door and rear passenger doors.
| *1 | Reinforcement | *2 | Rear Wheel Housing |
| *3 | Roof Side Inner Rear | *4 | Reinforcement |
Reinforcement patches, which provide the maneuvering stability, and a lower back bead have been added on the rear panel where the left and right rear floor side members are connected. This is done to enhance the rigidity in the horizontal direction of the vehicle body.
| *1 | Reinforcement patch | *2 | Lower Back Bead |
Spot welds have been added to the upper portion of the center pillar to enhance body rigidity.
By making the instrument panel reinforcement bracket a single piece, body rigidity has been enhanced.