Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM › 2013.08–2016.04
RM30M0E _58 Vehicle Interior _017117 SEAT BELT _0084737 SEAT BELT WARNING SYSTEM G

SEAT BELT  SEAT BELT WARNING SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT DRIVER SIDE SEAT BELT WARNING LIGHT

a.

Turn the ignition switch to ON.


b.

When the driver side seat belt is not fastened, check that the driver side seat belt warning light on the combination meter assembly blinks.


c.

When the driver side seat belt is fastened, check that the driver side seat belt warning light on the combination meter assembly is off.


Hide 2.INSPECT SEAT BELT WARNING BUZZER

HINT:

The seat belt warning buzzer can be customized. Make sure that this function is ON.

Click hereVehicle Interior>SEAT BELT>SEAT BELT WARNING SYSTEM>CUSTOMIZE PARAMETERS


a.

Lift up the vehicle using a swing arm type lift.


b.

Turn the ignition switch to ON.


c.

When the vehicle is driven at approximately 20 km/h (12 mph) or more while the driver side seat belt is unfastened, check that the buzzer in the combination meter assembly sounds at an interval of 1.2 seconds for 30 seconds. After that, check that the buzzer sounds at an interval of 0.4 seconds for 90 seconds. After that, check that the buzzer stops.


d.

After the buzzer has stopped, turn the ignition switch off.


e.

Drive the vehicle at approximately 20 km/h (12 mph) or more while the driver side seat belt is unfastened, and then check that the buzzer sounds again.


f.

After the buzzer has stopped, fasten the driver side seat belt. Drive the vehicle at approximately 20 km/h (12 mph) or more and unfasten the driver side seat belt, and then check that the buzzer sounds again.


g.

After the buzzer has stopped, move the shift lever to R, and then move it to D. Drive the vehicle at approximately 20 km/h (12 mph) or more, and then check that the buzzer sounds again.