Power is supplied to the radio receiver assembly illumination when the light control switch is in the tail or head position.
The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Inspect the fuses for circuits related to this system before performing the following procedure.
Check if the illumination for the radio receiver assembly, air conditioner control switch or others comes on when the light control switch is turned to the head or tail position.
| Result | Proceed to |
|---|---|
| Illumination comes on for all components except radio receiver assembly. | A |
| No illumination comes on (radio receiver assembly, hazard switch, air conditioner control switch, etc.). | B |
A
B
| *a | Front view of wire harness connector (to Radio Receiver Assembly) |
Disconnect the radio receiver assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F1-10 (ILL+) - Body ground | Light control switch in the tail or head position | 11 to 14 V |
| F1-7 (GND1) - Body ground | Always | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG