Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM › 2013.08–2016.04
RM30M0E _57 Power Source / Network _017152 NETWORKING _0084784 CAN COMMUNICATION SYSTEM U

NETWORKING  CAN COMMUNICATION SYSTEM  FAIL-SAFE CHART  


FAIL-SAFE FUNCTION


a.

When communication fails in any of the CAN bus lines (communication lines), a fail-safe function(s) will operate. The fail-safe function that is specified for each system operates to prevent those systems from malfunctioning.


b.

The following table shows the effects on each system when communication is impossible. (For further details, see the pages for each system.)

Function Control Master System Related Fail-safe Operation Driver Detectable DTC Detection
(ECU that stored DTC)
Anti-lock Brake System Control
·

Prevents the wheels from locking during sudden stops.


Brake actuator assembly Brake actuator assembly
·

During control: When back-up control (stabilizing the vehicle) is complete, the system changes to normal braking and prohibits control.

·

Not during control: Control cannot be performed.


ABS warning light illuminates. U0073
(Brake actuator assembly)
Air Conditioning Control
·

Corrects engine speed, such as for idle up.

·

Controls outlet air temperature, outlet mode change and airflow volume based on engine coolant temperature signal.

·

Corrects engine coolant temperature map and changes compressor lock judgment value.


Air conditioning amplifier assembly ECM
·

Control is performed based on default coolant temperature of 80°C (176°F).

·

Control is performed based on engine model (differs between vehicle models).


- U0100
(Air conditioning amplifier assembly)
Compressor Control
·

Determines whether the compressor is locked using engine speed information.


Air conditioning amplifier assembly ECM Control is performed based on default engine speed of 0 rpm. - U0100
(Air conditioning amplifier assembly)
Ambient Temperature Correction Control
·

Switches air conditioning system operation condition and corrects value of displayed ambient temperature according to vehicle speed signal.


Air conditioning amplifier assembly Combination meter assembly Control is performed based on default vehicle speed of 0 km/h (0 mph).
·

Correction level for displayed ambient temperature declines.

·

Correction level for outlet airflow declines.


U0155
(Air conditioning amplifier assembly)
Smart Function
·

Smart warning buzzer


Certification ECU (Smart key ECU assembly) Combination meter assembly - Smart warning buzzer does not operate. -
Tachometer
·

Displays information on the tachometer.


Combination meter assembly ECM Control is performed based on signal value of 0.
·

The tachometer displays 0 rpm.

·

The drive monitor stops calculating.


U0100
(Combination meter assembly)
Airbag Warning
·

Airbag warning light control.


Combination meter assembly Airbag ECU assembly Control is performed based on signal value of "Active". Airbag warning light illuminates. U0151
(Combination meter assembly)
Engine Coolant Temperature Receiver Gauge Control Combination meter assembly ECM Control is performed based on signal value of 0. Needle of engine coolant temperature receiver gauge is at the middle or below. -
Engine Start/Stop Switch (Power Source Mode Change)
·

Using start/stop switch signal as trigger, changes power source mode automatically and requests starter operation when conditions are met.


Certification ECU (Smart key ECU assembly) ECM - - U0100
(Certification ECU (Smart key ECU assembly))
Engine Start Control
·

Allows the engine to start by pressing the engine switch once. (Cranking hold)


Certification ECU (Smart key ECU assembly) ECM Cranking is stopped when engine starting is judged based on an engine speed signal received via direct line. - U0100
(Certification ECU (Smart key ECU assembly))