Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM30M0E _59 Vehicle Exterior _017121 WINDOW / GLASS _0086434 POWER WINDOW CONTROL SYSTEM D

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  OPERATION CHECK  


CHECK WINDOW LOCK SWITCH


HINT:

Before performing the window lock switch operation check, make sure that the window lock switch is off (the switch is not pushed in).


a.

Check that the front passenger and rear windows cannot be operated from each power window regulator switch assembly (front passenger side, rear LH side or rear RH side) when the window lock switch of the power window regulator master switch assembly is pushed in.

OK:

Front passenger side power window and rear power windows are disabled.



b.

Check that the front passenger and rear windows can be operated from each power window regulator switch assembly (front passenger side, rear LH side or rear RH side) when the window lock switch of the power window regulator master switch assembly is pushed in again.

OK:

Front passenger side power window and rear power windows operate normally.




CHECK MANUAL UP/DOWN FUNCTION


a.

Check that the driver side power window operates as follows:

OK
Condition Master Switch Switch Operation Power Window
Ignition switch ON Driver side Pulled halfway up UP (Closes)
Pushed halfway down DOWN (Opens)


b.

Check that the front passenger side power window and rear power windows operate as follows:

OK
Condition Regulator Switch Switch Operation Power Window
·

Ignition switch ON


·

Window lock switch off


Front passenger side Pulled halfway up UP (Closes)
Pushed halfway down DOWN (Opens)
Rear LH side Pulled halfway up UP (Closes)
Pushed halfway down DOWN (Opens)
Rear RH side Pulled halfway up UP (Closes)
Pushed halfway down DOWN (Opens)



CHECK AUTO UP/DOWN FUNCTION (for Driver Side)


a.

Check that the driver side power window operates as follows:

OK
Condition Master Switch Switch Operation Power Window
Ignition switch ON Driver side Fully Pulled up (One touch operation) Auto up (Fully closes)
Fully Pushed down (One touch operation) Auto down (Fully opens)



CHECK REMOTE MANUAL UP/DOWN FUNCTION


a.

Check that the front passenger side power window and rear power windows operate as follows:

OK
Condition Master Switch Switch Operation Power Window
·

Ignition switch ON


·

Window lock switch off


Front passenger side Pulled up UP (Closes)
Pushed down DOWN (Opens)
Rear LH side Pulled up UP (Closes)
Pushed down DOWN (Opens)
Rear RH side Pulled up UP (Closes)
Pushed down DOWN (Opens)



CHECK JAM PROTECTION FUNCTION (for Driver Side)


a.

Check the basic function.

CAUTION:

Do not put your fingers between the door frame and door glass to check the jam protection function. Also, prevent any part of your body from being caught during inspection.


HINT:

The jam protection function is operative during both the auto up and manual up operations while the ignition switch is ON.


i.

Fully open the window.


ii.
C281457
2.094,1.042 2.469,0.198 true 1.792,0.938 1.458,0.229 true 2.51,0.115 2.698,0.302 0.188,0.188 10 false *a 1.302,0.146 1.469,0.302 0.167,0.156 10 false *b
*a Thick Book
*b Cloth


Set a thick book wrapped with a piece of cloth near the window fully closed position.


iii.

Operate the auto up or manual up function to check that the power window goes down after the book is caught between the window and door frame, and stops when the opening reaches approximately 200 mm (7.87 in.).

HINT:

For example, if the window is closing and it detects contact with an obstacle 150 mm (5.91 in.) from the fully closed position, the window will reverse direction and move downward approximately 50 mm (1.97 in.).



iv.

While the power window is moving down, check that the door glass cannot be raised when the power window switch is used.




CHECK POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY LED ILLUMINATION (for Driver Side)


a.

Check the LED illumination (power window regulator master switch assembly).

i.

Check that the LED located on the power window regulator master switch assembly illuminates when the ignition switch is turned to ON.