INITIALIZE POWER WINDOW CONTROL SYSTEM (for Driver Side)
When the front power window regulator motor assembly is reinstalled or replaced, the power window control system must be initialized. Functions such as the auto up/down, jam protection do not operate if the initialization is not performed.
When the battery is replaced, it is not necessary to initialize the front power window regulator motor assembly.
When performing initialization, do not perform any other procedures.
Replacing the door glass or door glass run may cause a difference to exist between the current door glass position and the position memorized in the ECU. In this case, the jam protection function may work improperly. Return the system to the pre-initialized condition and reinitialize the system.
Disconnect the power window regulator motor connector during power window operation. This will return the motor to the pre-initialized condition.
The auto up function will not work unless initialization is completed.
Initialization procedure when replacing the front power window regulator motor assembly with a new one:
Connect the battery and turn the ignition switch to ON.
Fully open the window by fully pushing down the power window regulator master switch assembly, and hold the switch for 1 second or more after the window is fully opened.
Fully close the power window by fully pulling up the power window regulator master switch assembly, and hold the switch for 1 second or more after the window is fully closed to reset the glass position.
Initialization procedure when removing/installing the front power window regulator motor assembly:
Connect the battery and turn the ignition switch to ON.
Disconnect the power window regulator motor connector during power window operation. This will return the motor to the pre-initialized condition.
The auto up function will not work unless initialization is completed.
Fully close the door glass by operating the power window regulator master switch assembly. After the door glass stops, hold the power window regulator master switch assembly at the AUTO UP position for 1 second or more.
If the AUTO operation does not operate normally, this means that initialization has not been completed successfully. In this case, lower the door glass at least 50 mm (1.97 in.) and hold the power window regulator master switch assembly at the AUTO UP position for 1 second after the window closes fully.
Initialization procedure when the power window does not fully open:
Connect the battery and turn the ignition switch to ON.
Disconnect the power window regulator motor connector during power window operation. This will return the motor to the pre-initialized condition.
The auto up function will not work unless initialization is completed.
Fully close the door glass by operating the power window regulator master switch assembly. After the door glass stops, hold the power window regulator master switch assembly at the AUTO UP position for 1 second or more.
If the AUTO operation does not operate normally, this means that initialization has not been completed successfully. In this case, lower the door glass at least 50 mm (1.97 in.) and hold the power window regulator master switch assembly at the AUTO UP position for 1 second after the window closes fully.