IGNITION SWITCH EXPRESSIONS
The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
| Expression | Ignition Switch (Position) | Engine Switch (Condition) |
|---|---|---|
| Ignition Switch off | LOCK | Off (Lock) |
| Ignition Switch ACC | ACC | On (ACC) |
| Ignition Switch ON | ON | On (IG) |
| Engine Start | START | On (Start) |
POWER WINDOW CONTROL SYSTEM PRECAUTION
The power window control system prohibits the AUTO UP/DOWN function when the jam protection function malfunctions.
When the front power window regulator motor assembly (driver side) is reinstalled or replaced, the power window control system must be initialized.
Replacing the door glass or door glass run may cause a difference to exist between the current door glass position and the position memorized in the ECU. In this case, the jam protection function may work improperly. Return the system to the pre-initialized condition and reinitialize the system.
Disconnect the power window regulator motor connector during power window operation. This will return the motor to the pre-initialized condition.
The auto up function will not work unless initialization is completed.
The jam protection function may operate unexpectedly even when the power window control system is normal, due to detection of a different operation learned value when the door glass moving speed changes sharply under any of the following conditions:
A power window is opened or closed while the vehicle is being driven on a rough road.
A power window is opened or closed while the door is being opened or closed.
A sharp voltage change.