Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)
RM30M0E _58 Vehicle Interior _017118 HEATING / AIR CONDITIONING _0086573 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  IG Power Source Circuit  


DESCRIPTION

The main power source is supplied to the air conditioning amplifier assembly when the ignition switch is ON. This power is used for operating the air conditioning amplifier assembly, servo motors, etc.

WIRING DIAGRAM

E227906E05
0.073,0.729 1.5,1.365 1.427,0.635 10 false from Ignition or Starter Switch Assembly*1 or No. 1 Ignition Relay*2 2.531,0.885 3.427,1.146 0.896,0.26 10 false ECU-IG NO. 1 4.5,0.625 4.625,0.781 0.125,0.156 10 false 1 4.406,1.198 4.646,1.344 0.24,0.146 10 false 14 4.719,0.719 5.052,0.885 0.333,0.167 10 false IG+ 4.719,1.281 5.094,1.438 0.375,0.156 10 false GND 4.271,1.948 4.542,2.104 0.271,0.156 10 false F3 4.271,2.115 6.51,2.292 2.24,0.177 10 false Air Conditioning Amplifier Assembly 0.375,2.104 2.719,2.323 2.344,0.219 10 false *1: w/o Smart Entry and Start System 0.385,2.417 2.729,2.635 2.344,0.219 10 false *2: w/ Smart Entry and Start System

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - POWER SOURCE)
a.
E281476C02
1.479,0.115 1.927,0.323 0.448,0.208 0.323,1.177 0.198,1.677 true 1.615,0.115 1.927,0.313 0.313,0.198 10 false F3 0.104,1.688 0.417,1.896 0.313,0.208 10 false IG+ 0.146,0.104 0.458,0.302 0.313,0.198 10 false *a
*a Front view of wire harness connector (to Air Conditioning Amplifier Assembly)


Disconnect the air conditioning amplifier assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
F3-1 (IG+) - Body ground Ignition switch off Below 1 V
F3-1 (IG+) - Body ground Ignition switch ON 11 to 14 V



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)
a.
E281476C03
1.479,0.115 1.927,0.323 0.448,0.208 2.177,1.188 2.021,1.698 true 1.615,0.115 1.927,0.313 0.313,0.198 10 false F3 1.865,1.698 2.177,1.906 0.313,0.208 10 false GND 0.104,0.073 0.417,0.271 0.313,0.198 10 false *a
*a Front view of wire harness connector (to Air Conditioning Amplifier Assembly)


Disconnect the air conditioning amplifier assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F3-14 (GND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR