Home › Vehicle Exterior › WINDOW / GLASS › WINDOW DEFOGGER SYSTEM › 2013.08–2017.10
RM30M0E _59 Vehicle Exterior _017121 WINDOW / GLASS _0086992 WINDOW DEFOGGER SYSTEM U

WINDOW / GLASS  WINDOW DEFOGGER SYSTEM  TERMINALS OF ECU  


CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (for Automatic Air Conditioning System)


a.

Disconnect the F3 air conditioning amplifier assembly connector.

E238082E07
3.042,0.156 3.396,0.375 0.354,0.219 3.135,0.198 3.594,0.563 0.458,0.365 10 false F3


b.

Measure the voltage and resistance according to the value(s) in the table below.

HINT:

Measure the values on the wire harness side with the connector disconnected.


Tester Connection Wiring Color Terminal Description Condition Specified Condition
F3-1 (IG+) - F3-14 (GND) G - W-B Power source (IG) Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V
F3-21 (B) - F3-14 (GND) GR - W-B Battery power supply Always 11 to 14 V
F3-14 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction in the wire harness.


c.

Reconnect the F3 air conditioning amplifier assembly connector.


d.

Measure the voltage and check for pulses according to the value(s) in the table below.

Tester Connection Wiring Color Terminal Description Condition Specified Condition
F3-38 (RDFG) - F3-14 (GND) SB - W-B Rear window defogger signal Ignition switch ON, rear window defogger switch off 11 to 14 V
Ignition switch ON, rear window defogger switch on Below 1 V
F3-4 (LIN1) - F3-14 (GND) BE - W-B LIN communication line Ignition switch ON Pulse generation

If the result is not as specified, the air conditioning amplifier assembly may be malfunctioning.



CHECK AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)


a.

Disconnect the F4 air conditioning control assembly connector.

E238083E06
3.354,0.271 3.708,0.49 0.354,0.219 3.448,0.313 3.969,0.708 0.521,0.396 10 false F4


b.

Measure the voltage and resistance according to the value(s) in the table below.

HINT:

Measure the values on the wire harness side with the connector disconnected.


Tester Connection Wiring Color Terminal Description Condition Specified Condition
F4-8 (IG+) - F4-5 (GND) G - W-B Power source (IG) Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V
F4-5 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction in the wire harness.


c.

Reconnect the F4 air conditioning control assembly connector.


d.

Check for pulses according to the value(s) in the table below.

Tester Connection Wiring Color Terminal Description Condition Specified Condition
F4-2 (LIN1) - F4-5 (GND) BE - W-B LIN communication line Ignition switch ON Pulse generation

If the result is not as specified, the air conditioning control assembly may be malfunctioning.