89745C
1.REMOVE TRANSMITTER BATTERY
Take extra care when handling these precision electronic components.
| *a | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, pry apart the transmitter housing cover.
Do not use excessive force when prying apart the transmitter housing cover.
Remove the cover.
| *a | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, remove the transmitter battery (lithium battery: CR2032).
Do not push the terminals with your finger.
Do not forcibly pry up the transmitter battery. The terminals may be damaged.
Do not touch the transmitter battery with wet hands. Water may cause rust.
Do not touch or move any components inside the transmitter. It may interfere with proper operation.
When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical key transmitter sub-assembly from being damaged.
89745C
2.INSTALL TRANSMITTER BATTERY
Install a new transmitter battery (lithium battery: CR2032) with the positive (+) side facing upward, as shown in the illustration.
Do not bend the transmitter battery electrode during insertion.
Keep the transmitter housing case interior free of dust and oil.
When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical key transmitter sub-assembly from being damaged.
Install the cover.
Press down on the entire circumference of the cover.
Install the transmitter housing cover.
Press one of the transmitter switches and check that the LED illuminates.