89751A
1.REMOVE TRANSMITTER HOUSING COVER
| *a | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, pry apart the transmitter housing cover.
Do not use excessive force when prying apart the transmitter housing cover.
89071B
2.REMOVE DOOR CONTROL TRANSMITTER MODULE SET SUB-ASSEMBLY
Remove the door control transmitter module set sub-assembly.
89745A
3.REMOVE TRANSMITTER BATTERY
Disengage the 7 claws and remove the transmitter battery cover.
Remove the transmitter battery (lithium battery: CR1620) in the direction indicated by the arrow as shown in the illustration.
Do not push the terminals with your finger.
Do not use excessive force when prying up the transmitter battery (lithium battery: CR1620) as this may damage the terminals.
Do not touch the transmitter battery with wet hands. Water may cause it to rust.
Do not touch or move any components inside the transmitter as this may interfere with its proper operation.
When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter module set sub-assembly from being damaged.
89745A
4.INSTALL TRANSMITTER BATTERY
Install a transmitter battery (lithium battery: CR1620) with the positive (+) side up, as shown in the illustration.
Make sure that the positive (+) side and the negative (-) side of the transmitter battery are correctly matched with the transmitter terminals.
Do not bend the transmitter battery electrode during insertion.
Keep the transmitter battery case interior free of dust and oil.
When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter module set sub-assembly from being damaged.
Engage the 7 claws and install the transmitter battery cover.
89071B
5.INSTALL DOOR CONTROL TRANSMITTER MODULE SET SUB-ASSEMBLY
Install the door control transmitter module set sub-assembly.
89751A
6.INSTALL TRANSMITTER HOUSING COVER
Install the transmitter housing cover onto the transmitter housing case securely.