Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK(for TMT Made) › 2013.08–2017.10
RM30M0E _58 Vehicle Interior _017110 DOOR LOCK _0087449 REAR DOOR LOCK(for TMT Made) A

DOOR LOCK  REAR DOOR LOCK(for TMT Made)  INSTALLATION  


PROCEDURE

Hide 69740D 1.INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

a.

Engage the guide and install the rear door lock remote control cable assembly to the rear door lock assembly.


b.
B347085

Engage the 2 claws and close the cover in the direction indicated by the arrow as shown in the illustration.


Hide 69780B 2.INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY

a.

Engage the guide and install the rear door inside locking cable assembly to the rear door lock assembly.


b.
B347086

Engage the 3 claws and close the cover in the direction indicated by the arrow as shown in the illustration.


Hide 69340 3.INSTALL REAR DOOR LOCK ASSEMBLY

NOTICE:
·

When reusing the removed rear door lock assembly, replace the door lock wiring harness seal on the connector with a new one.

·

Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.

·

Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion. This may result in a malfunction of the rear door lock assembly.



a.

Apply MP grease to the sliding parts of the rear door lock assembly.


b.

When reusing the rear door lock assembly:

i.

Install a new door lock wiring harness seal to the rear door lock assembly.



c.
B347087

Insert the rear door lock assembly to the rear door outside handle release plate, and set it to the rear door panel.


d.

Make sure that the rear door outside handle frame sub-assembly release plate is securely connected to the rear door lock assembly.


e.

Using a T30 "TORX" socket wrench, install the rear door lock assembly with the 3 screws.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 68104 4.INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Hide 67408H 5.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

Hide 67872 6.CONNECT REAR DOOR WEATHERSTRIP

a.

Connect the upper part of rear door weatherstrip.


Hide 67842E 7.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 68152C 8.INSTALL REAR DOOR GLASS RUN

Hide 68174A 9.INSTALL REAR DOOR GLASS INNER WEATHERSTRIP

Hide 67604 10.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 74272A 11.INSTALL REAR DOOR ARMREST BASE UPPER PANEL (w/ Power Window)

Hide 74272A 12.INSTALL REAR DOOR ARMREST BASE UPPER PANEL (w/o Power Window)

Hide 69260E 13.INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

Hide 14.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)