The combination meter assembly communicates with the ECM, brake actuator assembly (skid control ECU) and airbag ECU assembly via the CAN communication system.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | Note |
|---|---|---|---|---|---|
| U0100 | Lost Communication with ECM / PCM "A" | When IG voltage is 9.5 V or more and the following condition is detected:
·
No communication with ECM continues for 2 seconds or more |
·
ECM ·
CAN communication system ·
Combination meter assembly |
DTC stored | - |
| U0129 | Lost Communication with Brake System Control Module | When IG voltage is 9.5 V or more and the following condition is detected:
·
No communication with brake actuator assembly (skid control ECU) continues for 3 seconds or more |
·
Brake actuator assembly (Skid control ECU) ·
CAN communication system ·
Combination meter assembly |
DTC stored | - |
| U0151 | Lost Communication with Restraints Control Module | When IG voltage is 9.5 V or more and the following condition is detected:
·
No communication with airbag ECU assembly continues for 10 seconds or more |
·
Airbag ECU assembly ·
CAN communication system ·
Combination meter assembly |
DTC stored | - |
Check if CAN communication DTCs are output.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| CAN communication DTCs are output. | A |
| CAN communication DTCs are not output. | B |
If CAN communication system DTC U0100, U0129 or U0151 and another DTC are output at the same time, perform troubleshooting for CAN communication system DTC U0100, U0129 or U0151 first.
A
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING