Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2013.08–2016.04
RM30M0E _58 Vehicle Interior _017113 METER / GAUGE / DISPLAY _0087658 METER / GAUGE SYSTEM G

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 83100 1.INSPECT COMBINATION METER ASSEMBLY

a.

Check speedometer operation (w/ ABS)

NOTICE:
·

The combination meter assembly receives the vehicle speed signal from the brake actuator assembly (skid control ECU) via CAN communication. Therefore, perform the following inspection referring to values on the Data List of the brake actuator assembly (skid control ECU) because it is the source of the vehicle speed signal.

·

The Data List values of the brake actuator assembly (skid control ECU) are used for this inspection. Therefore, make sure to perform this inspection after confirming that no DTCs are output from the brake control system.

·

If the tire size or tire inflation pressure is not within the specified range, or the tires are excessively worn, the speedometer indication error will increase. Therefore, make sure to perform this inspection after checking that the tire size, tire inflation pressure and tire wear are in the specified range.



i.

Before starting the following inspection, check if brake control system DTCs are output.


ii.

Check the values by referring to the table below.

Chassis > ABS/VSC/TRC > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Vehicle Speed Maximum wheel speed sensor reading Min.: 0 km/h (0 mph)
Max.: 326 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
Chassis > ABS/VSC/TRC > Data List
Tester Display
Vehicle Speed
50003 105 42
Reference km/h
GTS Indication (km/h) Acceptable Range (km/h)
20 21.0 to 25.0
40 41.7 to 46.2
60 62.7 to 67.2
80 83.4 to 88.4
100 104.3 to 109.3
120 125.1 to 130.6
140 145.8 to 151.8
160 166.2 to 173.2
180 186.9 to 194.5
200 207.7 to 215.7
220 228.4 to 236.8



b.

Inspect tachometer

i.

Connect the GTS and start the engine.


ii.

Compare the test results with the tachometer indication.

DC 13.5 V, at 25°C (77°F)
GTS Indication (rpm) Acceptable Range (rpm)
Data in ( ) is for Reference
700 630 to 770
1000 (900 to 1100)
2000 (1850 to 2150)
3000 2800 to 3200
4000 (3800 to 4200)
5000 4800 to 5200
6000 (5750 to 6250)
7000 6700 to 7300



c.

Check LED illumination (LED check)

i.

Check the illumination function of the warning or indicator lights listed below when turning the ignition switch to ON.

OK:
Warning or Indicator Light Specified Condition
ECO driving indicator*1 Warning or indicator light comes on for about 3 seconds after turning the ignition switch to ON.
Brake warning
ABS warning*2
Speed limit warning light*4
Water temperature hot warning
SRS warning*3 Warning light comes on for about 6 seconds after turning the ignition switch to ON.
MIL (Check engine warning light) Warning light comes on when turning the ignition switch to ON.
Charge warning
Engine oil pressure warning
EPS warning


*1: w/ Automatic Transaxle

*2: w/ ABS

*3: w/ Airbag System

*4: w/ Speed Warning