86160
1.INSPECT FRONT NO. 1 SPEAKER ASSEMBLY
Visually check.
The cone paper of the front No. 1 speaker assembly is not torn.
If the result is not as specified, replace the front No. 1 speaker assembly.
| *a | Component without harness connected (Front No. 1 Speaker Assembly) |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Always | 4 Ω |
If the result is not as specified, replace the front No. 1 speaker assembly.