CHECK COMBINATION METER ASSEMBLY
Disconnect the F38 combination meter assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
Measure the values on the wire harness side with the connector disconnected.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| F38-40 (B) - Body ground | B - Body ground | Battery power supply | Always | 11 to 14 V |
| F38-39 (IG+) - Body ground | SB - Body ground | IG power supply | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | |||
| F38-21 (ED) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| F38-1 (SW) - Body ground | BR - Body ground | Driver door courtesy light switch input | Driver door open | Below 1 Ω |
| Driver door closed | 10 kΩ or higher | |||
| F38-23 (KSWO) - Body ground | SB - Body ground | Unlock warning switch signal | No key in ignition key cylinder | 10 kΩ or higher |
| Key in ignition key cylinder | Below 1 Ω |
If the result is not as specified, there may be a malfunction on the wire harness side.