Home › Vehicle Interior › DOOR LOCK › KEY REMINDER WARNING SYSTEM
RM30M0E _58 Vehicle Interior _017110 DOOR LOCK _0089807 KEY REMINDER WARNING SYSTEM U

DOOR LOCK  KEY REMINDER WARNING SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Data List.


e.

Read the Data List according to the display on the GTS.

Body Electrical > Combination Meter > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
+B Voltage Value Battery voltage Min.: 0 V
Max.: 25.5 V
11 to 14 V -
Driver Side Door Driver door courtesy light switch signal CLOSE or OPEN CLOSE: Driver door closed
OPEN: Driver door opened
-
Key Remind Sound Cycle of the key reminder warning buzzer Normal, Slow or Fast Customize setting displayed -