Home › Vehicle Interior › HEATING / AIR CONDITIONING › BLOWER RESISTOR
RM30M0E _58 Vehicle Interior _017118 HEATING / AIR CONDITIONING _0090062 BLOWER RESISTOR G

HEATING / AIR CONDITIONING  BLOWER RESISTOR  INSPECTION  


PROCEDURE

Hide 87138C 1.INSPECT BLOWER RESISTOR (for LHD)

a.

Check the resistance.

i.
I105412
1.906,1.083 2.333,0.667 true 1.469,1.083 1.083,0.667 true 1.917,1.427 2.25,1.76 true 1.104,1.76 1.458,1.427 true 0.063,0.052 0.375,0.25 0.313,0.198 12 false *a 2.396,0.542 2.708,0.74 0.313,0.198 10 false E 0.854,0.542 1.167,0.74 0.313,0.198 10 false M2 2.323,1.688 2.635,1.885 0.313,0.198 10 false M1 0.979,1.688 1.167,1.917 0.188,0.229 10 false HI
*a Component without harness connected
(Blower Resistor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 (HI) - 2 (M2) Always 0.31 to 0.35 Ω
4 (HI) - 3 (M1) Always 1.07 to 1.23 Ω
4 (HI) - 1 (E) Always 3.12 to 3.58 Ω


If the result is not as specified, replace the blower resistor.



Hide 87138C 2.INSPECT BLOWER RESISTOR (for RHD)

a.

Check the resistance.

i.
I105412
1.906,1.083 2.333,0.667 true 1.469,1.083 1.083,0.667 true 1.917,1.427 2.25,1.76 true 1.104,1.76 1.458,1.427 true 0.063,0.052 0.375,0.25 0.313,0.198 12 false *a 2.396,0.542 2.708,0.74 0.313,0.198 10 false HI 0.854,0.542 1.167,0.74 0.313,0.198 10 false M1 2.323,1.688 2.635,1.885 0.313,0.198 10 false M2 0.979,1.688 1.167,1.917 0.188,0.229 10 false E
*a Component without harness connected
(Blower Resistor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance
Tester Connection Condition Specified Condition
1 (HI) - 3 (M2) Always 0.31 to 0.35 Ω
1 (HI) - 2 (M1) Always 1.07 to 1.23 Ω
1 (HI) - 4 (E) Always 3.12 to 3.58 Ω

If the result is not as specified, replace the blower resistor.