Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR(for 1NZ-FE, 2NZ-FE) › 2013.08–2016.10
RM30M0E _58 Vehicle Interior _017118 HEATING / AIR CONDITIONING _0090064 COMPRESSOR(for 1NZ-FE, 2NZ-FE) G

HEATING / AIR CONDITIONING  COMPRESSOR(for 1NZ-FE, 2NZ-FE)  INSPECTION  


PROCEDURE

Hide 88320 1.INSPECT COOLER COMPRESSOR WITH PULLEY ASSEMBLY

a.

Check the operation.

i.

Fix the cooler compressor with pulley assembly in a vise between aluminum plates.


ii.
I110030C01
0.083,0.063 0.396,0.26 0.313,0.198 10 false *a
*a Component without harness connected
(Cooler Compressor with Pulley Assembly)


Apply battery voltage and check the operation of the magnet clutch.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 1
Battery negative (-) → Body ground
Magnet clutch is engaged


If the result is not as specified, replace the cooler compressor with pulley assembly.