Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR(for 1NZ-FE, 2NZ-FE) › 2013.08–2016.10
RM30M0E _58 Vehicle Interior _017118 HEATING / AIR CONDITIONING _0090064 COMPRESSOR(for 1NZ-FE, 2NZ-FE) A

HEATING / AIR CONDITIONING  COMPRESSOR(for 1NZ-FE, 2NZ-FE)  DISASSEMBLY  


PROCEDURE

Hide 88403 1.REMOVE MAGNET CLUTCH HUB SUB-ASSEMBLY

a.

w/ No. 1 cooler cover:

i.
I109711

Disengage the wire harness clamp.


ii.

Remove the screw and ground wire to cooler bracket.



b.

w/o No. 1 cooler cover:

i.
I109987

Disconnect the connector.


ii.

Disengage the 2 guides.


iii.

Remove the screw and ground wire.



c.
I109710C01
1.313,1.865 1.125,1.552 true 1.646,1.604 2.208,1.51 true 0.688,1.208 0.604,0.552 true 1.167,1.865 1.625,2.063 0.458,0.198 10 false SST 2.26,1.396 2.573,1.594 0.313,0.198 10 false *a 0.51,0.375 0.823,0.573 0.313,0.198 10 false *b
*a Hold
*b Turn


Fix the cooler compressor with pulley assembly in a vise between aluminum plates.


d.

Using SST, hold the magnet clutch hub.

SST
09985-00270  


e.

Remove the bolt, magnet clutch hub and magnet clutch washer(s).

HINT:

There is no set number of magnet clutch washers(s) since they are used for adjusting.



f.
I109707

Using a snap ring expander, remove the snap ring.


g.

Remove the magnet clutch rotor.

NOTICE:

Do not damage the seal cover of the bearing when removing the snap ring.



h.
I109706

Using a snap ring expander, remove the snap ring.


i.

Remove the magnet clutch stator.