Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR(for 1NZ-FE, 2NZ-FE) › 2013.08–2016.10
RM30M0E _58 Vehicle Interior _017118 HEATING / AIR CONDITIONING _0090064 COMPRESSOR(for 1NZ-FE, 2NZ-FE) A

HEATING / AIR CONDITIONING  COMPRESSOR(for 1NZ-FE, 2NZ-FE)  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL MAGNETIC CLUTCH ASSEMBLY

a.
I109705

Install the magnet clutch stator with the parts shown in the illustration aligned.


b.
I109703

Using a snap ring expander, install a new snap ring with the chamfered side facing up.


c.

Install the magnet clutch rotor.


d.
I109704

Using a snap ring expander, install a new snap ring with the chamfered side facing up.

NOTICE:

Do not damage the seal cover of the bearing when installing the snap ring.



e.

Install the magnet clutch washer(s) and magnet clutch hub.

NOTICE:

Do not change the combination of the magnet clutch washer(s) used before disassembly.



f.
I109702C01
0.479,0.74 0.76,0.74 false 0.823,0.531 1.01,0.281 false 1.771,1.854 2.073,1.771 false 0.198,0.656 0.656,0.854 0.458,0.198 10 false SST 1.021,0.146 1.333,0.344 0.313,0.198 10 false *a 2.073,1.667 2.385,1.865 0.313,0.198 10 false *b
*a Hold
*b Turn


Using SST, hold the magnet clutch hub and install the bolt.

SST
09985-00270  

Torque:
13.2 N*m (135 kgf*cm, 10 ft.*lbf)

NOTICE:

Make sure that there is no foreign matter or oil on the compressor shaft, bolt, and magnet clutch hub.



Hide 2.INSPECT MAGNET CLUTCH CLEARANCE

a.
I110031

Set a dial indicator to the magnet clutch hub.


b.

Connect the battery positive lead to terminal 1 of the magnet clutch connector and negative lead to the ground wire. Turn the magnet clutch on and off and measure the clearance.

Standard clearance:

0.25 to 0.50 mm (0.00985 to 0.0196 in.)


If the measured value is not within the standard clearance, remove the magnet clutch hub and adjust the clearance using magnet clutch washers(s) to obtain the standard clearance.

Compressor washer thickness:

0.1 mm (0.00394 in.)

0.3 mm (0.0118 in.)

0.5 mm (0.0197 in.)


NOTICE:

Adjustment should be performed with 3 or fewer magnet clutch washers.



c.

Remove the cooler compressor with pulley assembly from the vise.


d.

w/ No. 1 cooler cover

i.

Install the cooler bracket and ground wire with the screw.


ii.

Engage the wire harness clamp.



e.

w/o No. 1 cooler cover

i.

Install the ground wire with the screw.


ii.

Engage the 2 guides.


iii.

Connect the connector.