Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR › 2013.08–2017.10
RM30M0E _58 Vehicle Interior _017118 HEATING / AIR CONDITIONING _0090066 FRONT EVAPORATOR TEMPERATURE SENSOR G

HEATING / AIR CONDITIONING  FRONT EVAPORATOR TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 88625 1.INSPECT NO. 1 COOLER THERMISTOR

a.

Check the resistance.

i.
I109635C02
0.24,0.927 0.656,0.51 false 1.396,3.021 1.813,2.604 false 1.927,0.177 2.24,0.375 0.313,0.198 10 false *a 0.708,0.385 1.021,0.583 0.313,0.198 10 false *b 0.198,1.594 0.51,1.792 0.313,0.198 10 false *d 1.865,2.438 2.177,2.635 0.313,0.198 10 false *c 3.177,4.438 3.396,4.625 0.219,0.188 10 false *e
*a Component without harness connected
(No. 1 Cooler Thermistor)
*b Sensing Portion
*c Acceptable Range
*d Resistance (kΩ)
*e Temperature (°C (°F))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 -10°C (14°F) 7.30 to 9.10 kΩ
1 - 2 -5°C (23°F) 5.65 to 6.95 kΩ
1 - 2 0°C (32°F) 4.40 to 5.35 kΩ
1 - 2 5°C (41°F) 3.40 to 4.15 kΩ
1 - 2 10°C (50°F) 2.70 to 3.25 kΩ
1 - 2 15°C (59°F) 2.14 to 2.58 kΩ
1 - 2 20°C (68°F) 1.71 to 2.05 kΩ
1 - 2 25°C (77°F) 1.38 to 1.64 kΩ
1 - 2 30°C (86°F) 1.11 to 1.32 kΩ


NOTICE:
·

Touching the sensor even slightly may change the resistance value. Hold the sensor connector.

·

When measuring the resistance, the temperature of the sensor and the cooler thermistor must be the same.



HINT:

As the temperature increases, the resistance decreases (see the graph). If the operation is not as specified, replace the No. 1 cooler thermistor.