Home › Vehicle Interior › HEATING / AIR CONDITIONING › AMBIENT TEMPERATURE SENSOR
RM30M0E _58 Vehicle Interior _017118 HEATING / AIR CONDITIONING _0090073 AMBIENT TEMPERATURE SENSOR G

HEATING / AIR CONDITIONING  AMBIENT TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 88790B 1.INSPECT THERMISTOR ASSEMBLY

a.

Check the resistance.

i.
I109806
3.115,1.458 3.021,0.823 true 1.521,3.198 1.979,2.854 true 0.292,0.208 0.604,0.406 0.313,0.198 10 false *a 3.063,1.5 3.375,1.698 0.313,0.198 10 false *b 0.104,3.042 0.417,3.24 0.313,0.198 10 false *c 1.99,2.729 2.302,2.927 0.313,0.198 10 false *e 1.833,4.396 2.146,4.594 0.313,0.198 10 false *d
*a Component without harness connected
(Thermistor Assembly)
*b Sensing Portion
*c Resistance (kΩ)
*d Temperature (°C (°F))
*e Acceptable Range


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 10°C (50°F) 3.00 to 3.73 kΩ
1 - 2 15°C (59°F) 2.45 to 2.88 kΩ
1 - 2 20°C (68°F) 1.95 to 2.30 kΩ
1 - 2 25°C (77°F) 1.60 to 1.80 kΩ
1 - 2 30°C (86°F) 1.28 to 1.47 kΩ
1 - 2 35°C (95°F) 1.00 to 1.22 kΩ
1 - 2 40°C (104°F) 0.80 to 1.00 kΩ
1 - 2 45°C (113°F) 0.65 to 0.85 kΩ
1 - 2 50°C (122°F) 0.50 to 0.70 kΩ
1 - 2 55°C (131°F) 0.44 to 0.60 kΩ
1 - 2 60°C (140°F) 0.36 to 0.50 kΩ


NOTICE:
·

Even slightly touching the sensor may change the resistance value. Be sure to hold the sensor connector.

·

When measuring, the thermistor assembly temperature must be the same as the ambient temperature.



HINT:

As the temperature increases, the resistance decreases (see the graph). If the result is not as specified, replace the thermistor assembly.