Home › Vehicle Exterior › WIPER / WASHER › FRONT WIPER MOTOR › 2013.08–2018.01
RM30M0E _59 Vehicle Exterior _017125 WIPER / WASHER _0090076 FRONT WIPER MOTOR A

WIPER / WASHER  FRONT WIPER MOTOR  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WIPER ARM HEAD CAP

HINT:

Use the same procedure for both sides.


a.
B347403C01
0.927,1.594 1.24,1.656 true 0.75,1.5 1.063,1.656 0.313,0.156 10 false *a
*a Protective Tape


Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws to remove the front wiper arm head cap.


Hide 2.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH

a.
B347404

Remove the nut and front wiper arm and blade assembly LH.


Hide 3.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 53867 4.REMOVE FRONT FENDER TO COWL SIDE SEAL LH

a.
B347405

Disengage the 2 pins and 3 claws to remove the front fender to cowl side seal LH.


Hide 53866 5.REMOVE FRONT FENDER TO COWL SIDE SEAL RH

HINT:

Use the same procedure as for the LH side.


Hide 55781E 6.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

a.
B348790

Remove the 2 clips.


b.

Disengage the 5 claws and 8 guides to remove the cowl top ventilator louver sub-assembly.


Hide 7.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

a.
B348544C01
2.167,0.708 1.844,0.302 true 1.688,0.146 2,0.344 0.313,0.198 10 true *1
*1 Motor Grommet


Disengage the clamp.


b.

Disconnect the connector.


c.

Remove the 2 bolts.


d.

Slide the windshield wiper motor and link assembly as shown in the illustration and disengage the motor grommet from the body to remove the windshield wiper motor and link assembly.

NOTICE:

Be careful not to damage the windshield glass when removing the windshield wiper motor and link assembly.



Hide 85110 8.REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

a.
B347408
1.573,1.76 1.448,1.365 true 1.531,1.781 1.844,1.938 0.313,0.156 10 false *a
*a Protective Tape


Using a screwdriver with its tip wrapped in protective tape, disconnect the wiper rod of the wiper link assembly from the crank arm pivot of the windshield wiper motor assembly, as shown in the illustration.


b.
B348786

Using a T30 "TORX" socket wrench, remove the 2 bolts and windshield wiper motor assembly from the wiper link assembly.