Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR(for Front Side)
RM30M0E _59 Vehicle Exterior _017125 WIPER / WASHER _0090079 WASHER MOTOR G

WIPER / WASHER  WASHER MOTOR  INSPECTION  


PROCEDURE

Hide 85310 1.INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

a.

Remove the washer jar.


b.

Disconnect the windshield washer motor and pump assembly connector.

HINT:

The check should be performed with the windshield washer motor and pump assembly installed on the washer jar.



c.

Fill the washer jar with washer fluid.


d.
E132855
0.073,0.063 0.552,0.417 0.479,0.354 10 false *a
*a Component without harness connected
(Windshield Washer Motor and Pump Assembly)


Connect the battery positive (+) lead to terminal 1 of the windshield washer motor and pump assembly, and the negative (-) lead to terminal 2.


e.

Check that washer fluid flows from the washer jar.

OK:

Washer fluid flows from the washer jar.


If the result is not as specified, replace the windshield washer motor and pump assembly.