85035
1.INSPECT WASHER NOZZLE SUB-ASSEMBLY
With the ignition switch to ON, check the position that the washer fluid hits the windshield glass.
Washer fluid hits the windshield glass in the areas shown in the illustration.
| *a | Upper Limit | *b | Standard |
| *c | Lower Limit | - | - |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 129.2 mm (5.09 in.) | B | 196.5 mm (7.74 in.) |
| C | 151.1 mm (5.95 in.) | D | 4.7 mm (0.185 in.) |
If the result is not as specified, replace the washer nozzle sub-assembly.