Home › Vehicle Exterior › HORN › RELAY
RM30M0E _59 Vehicle Exterior _017127 HORN _0090084 RELAY G

HORN  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 86530 1.INSPECT HORN RELAY ASSEMBLY

a.
B348540
1.667,0.75 2,0.75 true 2.646,0.75 2.979,0.75 true 2.542,1.125 2.958,1.125 true 2.521,1.604 2.938,1.604 true 0.219,1.302 0.344,1.5 0.125,0.198 10 false 1 0.229,0.76 0.385,0.958 0.156,0.198 10 false 5 1.24,0.771 1.375,0.958 0.135,0.188 10 false 3 1.229,1.292 1.385,1.49 0.156,0.198 10 false 2 3.042,1.031 3.198,1.229 0.156,0.198 10 false 5 3.042,1.521 3.198,1.719 0.156,0.198 10 false 3 3.052,0.646 3.208,0.844 0.156,0.198 10 false 2 1.531,0.677 1.688,0.875 0.156,0.198 10 false 1

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
3 - 5 Battery voltage applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the horn relay assembly.