Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
58910C
2.REMOVE REAR CONSOLE BOX ASSEMBLY
3.LOOSEN PARKING BRAKE CABLE
46430
4.SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY
5.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
6.REMOVE REAR DISC
7.DISCONNECT SKID CONTROL SENSOR WIRE
Using a screwdriver, disengage the claw of the connector lock portion and disconnect the skid control sensor wire connector.
8.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY
Remove the 4 bolts and rear axle hub and bearing assembly from the rear axle beam assembly.
Do not place the rear speed sensor side so that it is facing downward, and do not allow the rear speed sensor side to become damaged or contact foreign matter.
Do not drop the rear axle hub and bearing assembly.
The rear axle hub and bearing assembly is a component of the rear speed sensor.