Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM(for RH Side)
RM30M0E _53 Suspension _017095 FRONT SUSPENSION _0090098 FRONT LOWER SUSPENSION ARM(for RH Side) G

FRONT SUSPENSION  FRONT LOWER SUSPENSION ARM(for RH Side)  INSPECTION  


PROCEDURE

Hide 48068 1.INSPECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH

a.
C287611

Inspect the turning torque of the ball joint.

i.

Secure the front lower No. 1 suspension arm sub-assembly RH in a vise using aluminum plates.

NOTICE:

Do not overtighten the vise.



ii.

Install the nut to the ball joint stud.


iii.

Move the stud back and forth several times. Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take a torque reading on the 5th turn.

Standard turning torque:

0.78 to 3.43 N*m (8 to 34 kgf*cm, 7 to 30 in.*lbf)


If the turning torque is not within the specified range, replace the front lower No. 1 suspension arm sub-assembly RH with a new one.



b.

Inspect the dust cover.

i.

Check that the dust cover is not cracked and that there is no grease on it.