Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER(for Sedan)
RM30M0E _53 Suspension _017096 REAR SUSPENSION _0090103 REAR SHOCK ABSORBER N

REAR SUSPENSION  REAR SHOCK ABSORBER  DISPOSAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 48540 1.DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY

C231437
1.136,0.28 1.342,0.49 0.206,0.21 10 A 2.713,0.254 2.918,0.465 0.206,0.21 10 B

a.

Fully extend the rear shock absorber piston rod.


b.

Using a drill or similar tool, slowly make a hole in the area (A-B) shown in the illustration to discharge the gas inside.

CAUTION:

Always use proper safety equipment and since the discharging gas may cause chips to scatter, cover the drill with a piece of cloth when making the hole.


HINT:

The gas is colorless, odorless and harmless.