When a problem occurs in the electronic power steering system, the power steering warning light in the combination meter assembly comes on and the ECU stops the steering power assist, maintains the amount of power assist at a constant level or reduces the amount of power assist to protect the system.
| DTC Code | Malfunction | Fail-safe Operation |
|---|---|---|
| C1511 | Torque sensor malfunction | Assist force restricted or power assist stopped. |
| C1512 | ||
| C1513 | ||
| C1514 | ||
| C1515 | ||
| C1516 | ||
| C1517 | ||
| C1524 | Motor malfunction | |
| C1531 | Power steering ECU malfunction | |
| C1532 | ||
| C1533 | Temperature sensor malfunction in power steering ECU | |
| C1534 | EEPROM abnormal | |
| C1535 | Steering wheel location data error | |
| C1541 | Vehicle speed signal error | Assist force restricted. |
| C1542 | ||
| C1544 | Engine speed signal error | |
| C1545 | ||
| C1551 | IG power source voltage error | Power assist stopped. |
| C1552 | PIG power source voltage error | |
| C1553 | Overvoltage at IG and PIG terminals | |
| C1554 | Power source relay malfunction | |
| C1555 | Motor relay malfunction | |
| C1581 | Assist map mismatch written in power steering ECU assembly | Controlled using current default map. |
The amount of power assist may be decreased to prevent the motor and ECUs from overheating if the steering wheel is continuously turned when the vehicle is either stopped or driven at a low speed, or if the steering wheel is kept at either full lock position for a long time. In such cases, the amount of power assist returns to normal if the steering wheel is not turned for approximately 10 minutes with the engine idling.
If the battery is not sufficiently charged or the voltage decreases temporarily, the amount of power assist will be reduced and the EPS warning light will come on. In such cases, the amount of power assist returns normal when the battery voltage recovers.