Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR
RM30M0E _55 Steering _017105 STEERING GEAR / LINKAGE _0090115 STEERING GEAR A

STEERING GEAR / LINKAGE  STEERING GEAR  REMOVAL  


PROCEDURE

Hide 51201 1.REMOVE FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY

Hide 45025D 2.REMOVE NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY

C286502

a.

Remove the No. 1 steering column hole cover sub-assembly from the steering link assembly.


Hide 3.REMOVE STEERING LINK ASSEMBLY

a.
C286503

Remove the 2 bolts, 2 washers, 2 nuts and steering link assembly from the front suspension crossmember sub-assembly.

NOTICE:

Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut fixed in place.



Hide 4.SECURE STEERING LINK ASSEMBLY

a.
C251687C01
1.76,1.073 2.156,1.188 false 1.063,0.24 1.396,0.615 false 2.208,1.125 2.406,1.281 0.198,0.156 10 false *a 0.75,0.115 1.063,0.302 0.313,0.188 10 false SST
*a Protective Tape


Using SST wrapped in protective tape, secure the steering link assembly between aluminum plates in a vise.

SST
09612-00012  

NOTICE:

Do not tighten the nut of SST more than necessary.


HINT:

Tape SST before use.



Hide 45047 5.REMOVE TIE ROD END SUB-ASSEMBLY LH

a.
C283333C02
0.646,1.302 0.938,1.792 0.938,1.792 1,1.292 true 0.906,1.865 1.219,2.021 0.313,0.156 10 false *a
*a Matchmark


Put matchmarks on the tie rod end sub-assembly LH and steering gear assembly.


b.

Remove the tie rod end sub-assembly LH and lock nut.


Hide 45046 6.REMOVE TIE ROD END SUB-ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.