Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR
RM30M0E _55 Steering _017105 STEERING GEAR / LINKAGE _0090115 STEERING GEAR G

STEERING GEAR / LINKAGE  STEERING GEAR  INSPECTION  


PROCEDURE

Hide 45047 1.INSPECT TIE ROD END SUB-ASSEMBLY LH

a.

Inspect the turning torque of the ball joint.

i.
C132329

Secure the tie rod end sub-assembly LH in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.



ii.

Install the nut to the stud bolt.


iii.

Flip the ball joint back and forth 5 times.


iv.

Set a torque wrench on the nut, turn the ball joint continuously at a rate of 2 to 4 seconds per turn, and check the turning torque on the 5th turn.

Standard turning torque:

0.5 to 3.5 N*m (6 to 35 kgf*cm, 5 to 30 in.*lbf)


If the turning torque is not within the specified range, replace the tie rod end sub-assembly LH with a new one.



Hide 45046 2.INSPECT TIE ROD END SUB-ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 45510 3.INSPECT STEERING GEAR ASSEMBLY TOTAL PRELOAD

a.

Inspect the total preload.

i.
C287411
2.094,0.792 2.531,0.385 true 2.573,0.281 2.875,0.479 0.302,0.198 10 false SST

Using SST and a torque wrench, turn the pinion shaft continuously at a rate of 4 to 6 seconds per turn to inspect the total preload of the steering gear assembly.

SST
09616-00011  

Standard turning torque:

0.6 to 1.2 N*m (7 to 12 kgf*cm, 6 to 10 in.*lbf)


NOTICE:
·

Remove the steering rack boots before measurement.

·

Move the steering rack through 1 or 2 full strokes to ensure that it is moving smoothly.

·

Inspect the total preload around the steering rack center position.



If the total preload is not within the specified range, replace the steering gear assembly with a new one.