Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR
RM30M0E _55 Steering _017105 STEERING GEAR / LINKAGE _0090115 STEERING GEAR A

STEERING GEAR / LINKAGE  STEERING GEAR  INSTALLATION  


PROCEDURE

Hide 45047 1.INSTALL TIE ROD END SUB-ASSEMBLY LH

a.
C283333C02
0.646,1.302 0.938,1.792 0.938,1.792 1,1.292 true 0.906,1.865 1.219,2.021 0.313,0.156 10 false *a
*a Matchmark


Install the lock nut and tie rod end sub-assembly LH to the steering gear assembly until the matchmarks are aligned.

HINT:

After adjusting toe-in, tighten the lock nut to the specified torque.



Hide 45046 2.INSTALL TIE ROD END SUB-ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 3.INSTALL STEERING LINK ASSEMBLY

a.

Install the steering link assembly to the front suspension crossmember sub-assembly with the 2 bolts, 2 washers and 2 nuts.

Torque:
78.5 N*m (800 kgf*cm, 58 ft.*lbf)

NOTICE:
·

Be sure to tighten the bolts starting from the right side of the vehicle.

·

Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut fixed in place.




Hide 45025D 4.INSTALL NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY

a.

Install the No. 1 steering column hole cover sub-assembly to the steering link assembly.


Hide 51201 5.INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY