1.INSPECT PRELOAD
Inspect the preload.
Secure the steering column assembly in a vise using aluminum plates and wooden blocks.
Do not overtighten the vise.
| *a | Wooden Block |
Using SST and a torque wrench, turn the steering main shaft at a constant rate of approximately 1 revolution every 4 seconds and measure the preload.
1.42 N*m (14 kgf*cm, 13 in.*lbf)
If the preload is not as specified, replace the power steering motor assembly or steering column assembly with a new one.
2.INSPECT STEERING LOCK OPERATION (w/o Smart Entry and Start System)
Remove the key and check that the steering lock function is activated.
Insert the key, turn the ignition switch to ACC and check that the steering lock function has been deactivated.
If there is any abnormality, replace the ignition switch lock cylinder and key set.
3.INSPECT STEERING COLUMN ASSEMBLY
Check that the 2 bushings are securely installed to the steering column assembly.
If the bushings are deformed, missing or damaged, replace the steering column assembly with a new one.