Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › SFI SYSTEM(for Automatic Transaxle) › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017071 1NZ-FE ENGINE CONTROL _0090157 SFI SYSTEM(for Automatic Transaxle) U

1NZ-FE ENGINE CONTROL  SFI SYSTEM(for Automatic Transaxle)  FAIL-SAFE CHART  


If any of the following DTCs are stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily.

DTC No. Component Fail-Safe Operation Fail-Safe Deactivation Condition
P0011 Camshaft Timing Oil Control Valve Assembly
·

Idle up (Control of combustion worsening)

·

Stopping fuel-cut control


Pass condition detected
P0031
P0032
P0037
P0038
Heated oxygen sensor heater ECM turns off heated oxygen sensor heater. Ignition switch off
P0100
P0102
P0103
Mass air flow meter ECM calculates ignition timing according to engine speed and throttle valve position. Pass condition detected
P0110
P0112
P0113
Intake air temperature sensor ECM estimates intake air temperature to be 20°C (68°F). Pass condition detected
P0115
P0117
P0118
Engine coolant temperature sensor ECM estimates engine coolant temperature to be 80°C (176°F). Pass condition detected
P0120
P0121
P0122
P0123
P0220
P0222
P0223
P0604
P0606
P060A
P060D
P060E
P0657
P2102
P2103
P2111
P2112
P2118
P2119
P2135
Throttle body with motor assembly ECM cuts off throttle actuator current and throttle valve is returned to 6° throttle position by return spring.
ECM then adjusts engine output by controlling fuel injection (intermittent fuel-cut) and ignition timing in accordance with accelerator pedal angle to allow vehicle to continue to be driven at minimal speed *1.
Pass condition detected and then ignition switch turned off
P0327
P0328
Knock sensor ECM sets ignition timing to maximum retard. Ignition switch off
P0351
P0352
P0353
P0354
No. 1 Ignition coil ECM cuts fuel. Pass condition detected
P2120
P2121
P2122
P2123
P2125
P2127
P2128
P2138
Accelerator pedal sensor assembly Accelerator pedal position sensor has 2 sensor circuits: Main and Sub.
If either circuit malfunctions, ECM limits the engine output.
If both circuits malfunction, ECM regards accelerator pedal as being released. As a result, throttle valve is closed and engine idles.
Pass condition detected and then ignition switch turned off

HINT:

*1: The vehicle can be driven slowly when the accelerator pedal is depressed firmly and slowly. If the accelerator pedal is depressed quickly, the vehicle may speed up and slow down erratically.