Home › Engine / Hybrid System › 1NZ-FE FUEL › FUEL PUMP › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017075 1NZ-FE FUEL _0090166 FUEL PUMP A

1NZ-FE FUEL  FUEL PUMP  DISASSEMBLY  


PROCEDURE

Hide 83320 1.REMOVE FUEL SENDER GAUGE ASSEMBLY

Hide 77785 2.REMOVE FUEL PUMP HARNESS

a.
A311722

Disconnect the 2 connectors to remove the fuel pump harness from the fuel suction tube assembly and fuel pump.


Hide 23221 3.REMOVE FUEL PUMP

a.
A311721

Disengage the 3 claws to remove the fuel pump and fuel pump filter from the No. 1 fuel suction support.

NOTICE:

Do not damage the fuel pump filter.



b.
A246971

While holding the fuel pump filter by the plastic resin part, remove the fuel pump from the fuel pump filter.

NOTICE:

Be careful not to let foreign matter enter the fuel pump or fuel pump filter.



c.
A248126C03
2.229,0.667 2.563,0.51 false 2.229,0.813 2.552,0.927 false 2.594,0.438 2.76,0.594 0.167,0.156 10 false *1 2.573,0.854 2.74,1.01 0.167,0.156 10 false *2 2.229,1.833 2.396,1.99 0.167,0.156 10 false *a 2.271,2.375 2.438,2.531 0.167,0.156 10 false *a
*1 O-ring
*2 Fuel Pump Spacer
*a 5 mm (0.1969 in.)


Remove the O-ring and fuel pump spacer from the fuel pump.

NOTICE:

Be careful not to damage the sealing surface.


HINT:

If the O-ring still remains in the No. 1 fuel suction support, remove it using a wire tip (φ1 mm (0.0394 in.)) that is formed as shown in the illustration.