23221
1.INSTALL FUEL PUMP
While holding the fuel pump filter by the plastic resin part, install the fuel pump to the fuel pump filter.
Be careful not to let foreign matter enter the fuel pump or fuel pump filter.
| *1 | O-ring |
| *2 | Fuel Pump Spacer |
Apply gasoline to a new O-ring and then install the fuel pump spacer and O-ring to the fuel pump.
Make sure the O-ring is not damaged and has no foreign matter stuck to it.
Engage the 3 claws to install the fuel pump and fuel pump filter to the No. 1 fuel suction support.
Do not push the filter part of the fuel pump filter.
77785
2.INSTALL FUEL PUMP HARNESS
Connect the 2 connectors to install the fuel pump harness to the fuel suction tube assembly and fuel pump.
83320
3.INSTALL FUEL SENDER GAUGE ASSEMBLY