Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › 2013.08–2016.04
RM30M0E _54 Brake _017098 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0090184 ANTI-LOCK BRAKE SYSTEM D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  CHECK FOR INTERMITTENT PROBLEMS  


CHECK FOR INTERMITTENT PROBLEMS


HINT:

A momentary interruption (open circuit) in the connectors and/or wire harnesses between the sensors and ECUs can be detected using the ECU Data List function of the GTS.


a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Follow the directions on the GTS to display the Data List and select areas where momentary interruptions should be monitored.

HINT:
·

A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).

·

If the Error display remains displayed, measure the resistance between the ECUs and sensors, or between ECUs.

·

The Error display on the GTS will remain displayed for 1 second after the harness signal changes from momentary interruption (open circuit) to the normal condition.



Chassis > ABS/VSC/TRC > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
FR Speed Open FR speed sensor open detection Normal or Error Normal: Normal
Error: Momentary interruption
-
FL Speed Open FL speed sensor open detection Normal or Error Normal: Normal
Error: Momentary interruption
-
RR Speed Open RR speed sensor open detection Normal or Error Normal: Normal
Error: Momentary interruption
-
RL Speed Open RL speed sensor open detection Normal or Error Normal: Normal
Error: Momentary interruption
-
EFI Communication Open EFI communication open detection Normal or Error Normal: Normal
Error: Momentary interruption
-
Deceleration Open Deceleration sensor open detection Normal or Error Normal: Normal
Error: Momentary interruption
-
IG Voltage Value Decreased IG voltage value decrease detection Normal or Error Normal: Normal
Error: Momentary interruption
-
IG Voltage Value Increased IG voltage value increase detection Normal or Error Normal: Normal
Error: Momentary interruption
-
FR Speed Sensor Voltage Open Front speed sensor RH voltage open detection Normal or Error Normal: Normal
Error: Momentary interruption
-
FL Speed Sensor Voltage Open Front speed sensor LH voltage open detection Normal or Error Normal: Normal
Error: Momentary interruption
-
RR Speed Sensor Voltage Open Rear speed sensor RH voltage open detection Normal or Error Normal: Normal
Error: Momentary interruption
-
RL Speed Sensor Voltage Open Rear speed sensor LH voltage open detection Normal or Error Normal: Normal
Error: Momentary interruption
-

f.

While observing the screen, gently jiggle the connector or wire harness between the ECU and sensors, or between ECUs.

OK:

Error display does not change.


HINT:

If the display changes, the connector and/or the wire harness has caused a momentary interruption of the circuit. Repair or replace the connector and/or wire harness as one of them is faulty.