1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DRAIN BRAKE FLUID
If brake fluid leaks onto any painted surface, immediately wash it off.
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
28800
4.REMOVE BATTERY
74431
5.REMOVE BATTERY TRAY
74410
6.REMOVE BATTERY CARRIER ASSEMBLY
Disengage the 6 clamps to separate the wire harness from the battery carrier assembly.
Remove the 6 bolts and battery carrier assembly from the body.
44510
7.REMOVE BRAKE ACTUATOR ASSEMBLY (for LHD)
| *a | Lock Lever |
Release the lock lever to disconnect the brake actuator connector.
Be careful not to allow brake fluid to enter the removed connector.
Using a 10 mm union nut wrench, disconnect the 6 brake tubes from the brake actuator assembly.
| *a | to Front Wheel Cylinder RH |
| *b | to Front Wheel Cylinder LH |
| *c | to Rear Wheel Cylinder RH |
| *d | to Rear Wheel Cylinder LH |
| *e | from Front Master Cylinder |
| *f | from Rear Master Cylinder |
Use tags or make a memo to identify the places to reconnect the brake tubes.
Remove the 3 bolts and brake actuator assembly with the brake actuator bracket assembly.
Do not damage the brake tubes or wire harness.
Do not carry the brake actuator assembly with the brake actuator bracket assembly by the connector.
44510
8.REMOVE BRAKE ACTUATOR ASSEMBLY (for RHD)
| *a | Lock Lever |
Release the lock lever to disconnect the brake actuator connector.
Be careful not to allow brake fluid to enter the removed connector.
Using a 10 mm union nut wrench, disconnect the 6 brake tubes from the brake actuator assembly.
| *a | to Front Wheel Cylinder RH |
| *b | to Front Wheel Cylinder LH |
| *c | to Rear Wheel Cylinder RH |
| *d | to Rear Wheel Cylinder LH |
| *e | from Rear Master Cylinder |
| *f | from Front Master Cylinder |
Use tags or make a memo to identify the places to reconnect the brake tubes.
Remove the 3 bolts and brake actuator assembly with the brake actuator bracket assembly.
Do not damage the brake tubes or wire harness.
Do not carry the brake actuator assembly with the brake actuator bracket assembly by the connector.
44590
9.REMOVE BRAKE ACTUATOR BRACKET ASSEMBLY (for LHD)
Remove the 3 bolts and brake actuator bracket assembly from the brake actuator assembly.
Do not carry the brake actuator assembly by the connector.
44590
10.REMOVE BRAKE ACTUATOR BRACKET ASSEMBLY (for RHD)
Remove the 3 bolts and brake actuator bracket assembly from the brake actuator assembly.
Do not carry the brake actuator assembly by the connector.
44546A
11.REMOVE BRAKE ACTUATOR BRACKET CUSHION
Remove the 3 brake actuator case collars from the 3 brake actuator bracket cushions.
Remove the 3 brake actuator bracket cushions from the brake actuator bracket assembly.