Home › Engine / Hybrid System › 1NZ-FE COOLING › COOLING SYSTEM › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017081 1NZ-FE COOLING _0090200 COOLING SYSTEM G

1NZ-FE COOLING  COOLING SYSTEM  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:

Be sure that the ignition switch is off if you work near the electric cooling fans or radiator grille. With the ignition switch ON, the electric cooling fans may automatically start to run if the engine coolant temperature is high and/or the air conditioning is on.


PROCEDURE

Hide 1.INSPECT FOR COOLANT LEAK

CAUTION:

Do not remove the water filler cap sub-assembly while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


a.
A250661C01
0.833,0.771 0.583,0.375 false 0.417,0.292 0.583,0.458 0.167,0.167 10 false *a
*a Radiator Cap Tester


Fill the radiator assembly with TOYOTA Super Long Life Coolant (SLLC), then attach a radiator cap tester.

HINT:

TOYOTA vehicles are filled with TOYOTA SLLC at the factory. In order to avoid damage to the engine cooling system and other technical problems, only use TOYOTA SLLC or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite, non-borate engine coolant with long-life hybrid organic acid technology (engine coolant with long-life hybrid organic acid technology is a combination of low phosphates and organic acids).



b.

Pump the radiator cap tester to 137 kPa (1.4 kgf/cm2, 19.9 psi), then check that the pressure does not drop.

If the pressure drops, check the hoses, radiator assembly and engine water pump assembly for leakage. If there are no signs or traces of external engine coolant leakage, check the cylinder block sub-assembly and cylinder head sub-assembly.


Hide 2.INSPECT RESERVOIR TANK COOLANT LEVEL

a.
A246002C07
2.115,0.99 2.531,0.833 true 2.188,1.646 2.573,1.479 true 2.542,0.729 2.781,0.938 0.24,0.208 10 false *a 2.604,1.396 2.844,1.604 0.24,0.208 10 false *b
*a Full Line
*b Low Line


The engine coolant level should be between the Low and Full lines when the engine is cold.

HINT:

If it is below the Low line, check for leakage and add Toyota Super Long Life Coolant (SLLC) or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite, and non-borate engine coolant with long-life hybrid organic acid technology up to the Full line.



Hide 3.INSPECT ENGINE COOLANT QUALITY

CAUTION:

Do not remove the water filler cap sub-assembly while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


a.

Remove the water filler cap sub-assembly.


b.

Check for excessive deposits of rust or scale around the water filler cap sub-assembly and radiator filler hole. The engine coolant should be free of oil.

If excessively dirty, replace the engine coolant.


c.

Install the water filler cap sub-assembly.