Home › Engine / Hybrid System › 1NZ-FE COOLING › THERMOSTAT › 2013.08–2016.10
RM30M0E _51 Engine / Hybrid System _017081 1NZ-FE COOLING _0090204 THERMOSTAT G

1NZ-FE COOLING  THERMOSTAT  INSPECTION  


PROCEDURE

Hide 16331A 1.INSPECT THERMOSTAT

HINT:

The valve opening temperature is inscribed on the thermostat.


a.

Check the operation.

i.
A302933

Immerse the thermostat in water and gradually heat the water.

CAUTION:

Make sure not to burn yourself.



ii.

Check the valve opening temperature of the thermostat.

Valve opening temperature:

80 to 84°C (176 to 183°F)


If the valve opening temperature is not as specified, replace the thermostat.


iii.
A302934C01
2.5,1.656 2.813,1.813 0.313,0.156 10 false *a
*a Valve Lift


Check the valve lift.

Valve lift:

8.5 mm (0.335 in.) or more at 95°C (203°F)


If the valve lift is not as specified, replace the thermostat.


iv.

Check that the valve is fully closed when the thermostat is at low temperatures (below 77°C (171°F)).

If not fully closed, replace the thermostat.